SARV COAT 2735

vinyl red oxie primer COATINGS

Description

Sarv coat 2735 is a general purpose vinyl red oxide primer based on vinyl copolymer resin.

Physical Data

Finish............................................... Flat

Colour............................................. Red-Brown

Volume Solids............................... 32±2%

Specific Gravity............................ 1.33 ±0.05 gr/m³

Flash Point..................................... 23°C

Recommended D.F.T................... 40-60 microns

Theoretical coverage.................... 8-5.33 sqm/lit

                                                          6.4 sqm/lit

Practical Coverage....................... depends on loss factor

Touch dry....................................... 2 hrs at 20°C

Hard dry......................................... 1 days at 20 °C

Shelf life......................................... 1 year at 25°C

Thermal Resistance...................... continuous 80°C

Package.......................................... 20 liter container

Application Details

Application method .................... Air/Airless spray, Brush

Nozzle orifice................................. . .019"-.021"

Nozzle pressure............................. 150 bar/2200 Psi

Application temperature............. 10 - 40°C

Mixing ratio................................... single pack

Thinner/Cleaner............................ SVT- 27

Pot life ............................................ N/A

Recoat interval.............................. Min 24 hrs

                                                          Max 2 moths

Outstanding Characteristics

• Rust Rreventing
• Excellent sprayability
• Exellent flexibility.
• Good Resistance in midly to moderately corrosive environment

Recommended Use

As versatile primer for vinyl system on steel structures exposed in moderately to severly industrial & marine corrosive environments.

Surface Preparation

Remove oil and grease, etc. with suitable detergent. Remove salt and other contaminants by (high pressure) fresh water cleaning. Clean damaged area thoroughly by power tool cleaning to ST3 (minor areas)

Or by abrasive blasting to minimum SA2, Preferably to SA2 ½ (For repair and maintenance)

Abrasive blasting to Sa 2½, SSPC-10 (for new steel)