SARV COAT 8732

Epoxy polyamide high build COATINGS

Description

Sarv coat 8732 is a two component polyamide cured, high build epoxy coating, applicable as intermediate & topcoat.

Physical Data

Finish............................................... Semi gloss

Colour............................................. Upon request

Volume Solids............................... 65±2%

Specific Gravity............................ 1.40±0.05 gr/cm³

Flash Point..................................... 26°C

Recommended D.F.T................... 100-125 microns

Theoretical coverage.................... 6.5- 5.2 m²/lit

                                                          4.6- 3.7 m²/kg

Practical Coverage....................... Depends on loss factor

Touch dry....................................... 2 hrs at 20°C

Fully cured..................................... 1 week at 20°C

Thermal Resistance...................... Continuous 110 °C

                                                     Non-Continuous 130°C

Shelf life......................................... 24 month at 20°C

Package.......................................... 4 & 20 liter container

Application Details

Application method .................... Air/Airless spray, Brush

Nozzle orifice................................. . .019" - .021"

Nozzle pressure............................. 150 bar/2200 Psi

Application temperature............. .10-50°C

Mixing ratio................................... Refer to the can label

Thinner/Cleaner............................ SVT-87

Pot life ............................................ 4 hrs at 20°C

Recoat interval.............................. Min 24 hrs

                                                     Max 72 hrs

Outstanding Characteristics

• Excellent oil resistance
• Excellent chemical resistance against weak acids and alkalies
• Resistance to transit and handling damages
• Corrosion resistance in moderately to severely to severely marine & industrial environment

Recommended Use

As a high build, high performance protective coating in aggressive environment over concrete or metal substrate (interior and exterior surfaces).

Surface Preparation

The surface must be clean and dry.All dirt,grease,mill-scales and any other foreign materials should be removed.

Sand blasting or wire brushing to a standard of ST 2 is required.