SARV COAT 6120

alkyd baking enamel COATINGS



Description

Sarv coat 6120 is a baking glossy topcoat based on a modified alkyd resin.

 

Physical Data

 

Finish............................................... Gloss, Semi gloss

Colour............................................. Upon request

Volume Solids............................... 42±3%

Specific Gravity............................ 1.15±0.1 gr/cm3

                                                          (black: 10)

Flash Point..................................... 26°C

Recommended D.F.T................... 25-40 microns

Theoretical coverage.................... 16.8-10.5 sqm/lit.

                                                          14.6-9.1 sqm/kg

Practical Coverage....................... Depends on loss factor

Flashing time................................. 10 min

Stoving time................................... 15-20 min at 160°C

Shelf life ........................................ 12 months at 25°C

Package.......................................... 20 liter container

 

Application Details

Application method..................... Air /Airless spray, Brush, Roller, deep

Nozzle orfice.................................. .021"

Nozzle pressure............................. 150 bar/2200 Psi

Application temperature............. 10-50°c

Mixing ratio................................... single pack

Thinner/Cleaner............................ SVT-61

Pot life ............................................ N/A

Recoat interval.............................. Wet on wet or after .

                                                           Partially curing

Outstanding Characteristics

  • High gloss and colour retention
  • Excellent sprayability
  • High adhesion to differente metallic surfaces
  • Excellent flexibility
  • Electrostaticly applicable.

Recommended Use

For use on metal surfaces where a hard glossy and adherant oily finish coat is required, specially in home appliances.

Surface Preparation

Remove oil and grease, etc. with suitable detergent. Remove salt and other contaminants by (high pressure) fresh water cleaning. Clean damaged area thoroughly by power tool cleaning to ST3 (minor areas)

Or by abrasive blasting to minimum Sa2, Preferably to Sa2½ (for repair and maintenance) Abrasive blasting to Sa 2½ SSPC10 -(for new steel)